Hope2SleepGuide

Sleep Apnoea Forum Bringing Help + Support to the Patient

Hi, wonder if anyone can help me, I am looking for a DC power lead without the car lighter attachment for my Philips REMstar Auto A-Flex. I'm currently using an inverter and a leisure battery when caravanning and not hooked up to mains electricity. The inverter is exceedingly noisy but is worth it for a good nights sleep but it does drain the battery quite quickly.

Views: 106

Reply to This

Replies to This Discussion

If you are good with a soldering iron you could make one.

Or you could buy one with a car lighter plug and get and car lighter extension lead, these normally have crocodile clips on the end.  Just be careful with the polarity on both leads.

Trace the wires out with a multi-meter, or get someone to check it for you.

Do not mix the connections up when you connect it to a battery.



Sleep2snore said:

If you are good with a soldering iron you could make one.

Or you could buy one with a car lighter plug and get and car lighter extension lead, these normally have crocodile clips on the end.  Just be careful with the polarity on both leads.

Trace the wires out with a multi-meter, or get someone to check it for you.

Do not mix the connections up when you connect it to a battery.

I'm not to bad with a soldering iron but where can I get the extension lead from? I've seen the lead with car lighter attachment but not the other one. However I wouldn't want to damage my machine.

I got one from an AUTO parts company.  Most car accessory shops should stock them or could get you one.

Wish I could remember where I put it, I could use it now!

It used to be with the tyre compressor, but I can't find it.

A thing to watch when using DC power leads is some machines use the centre pin being negative instead of positive as in most cars these days, so be careful when connecting DC power leads.

Also car batteries are not the best to power a CPAP machine off as if the car battery is discharged more that 30% it can start to eat at the battery and dissolve the plates that supply the power.  If using a battery t is best to use a leisure battery, these have heavier plates inside and can be discharged and then recharged without damage (you must charge them up after you use them or store them for any length of time) these batteries are designed for deep cycle discharge and recharge.  They will not get dissolved so quickly and can be discharged 60-70% without any damage to the battery and can be run flatter if need be as long as you charge them right away.

Some machines you can use with a DC to DC adaptor, these adaptors allow you to run on 24vDC as well as 12vDC and will cut the power off if the battery gets lower that 30% discharge, they also protect against reversed polarity.

Unfortunately, the manufacturer has decided to stop making these adaptors.  

Watch the polarity as a mistake will break the machine, there is a diode inside the machine that will blow an internal fuse if you get it wrong (if you are lucky) or it might do more damage.  The fuse is tiny and not something most people could fix as they are usually soldered to the circuit board.  Even if you could get one, I would recommend trying to fix it.

Hi, thanks for all your advice and I did a lot of research but in the end bought both parts compatible with my machine, suffice to say I no longer have to use a noisy inverter and the battery(leisure) lasts longer.

Some of these machines are 24VDC, such as some of the new Resmed machines, just to make life complicated.

You need a 12Vdc to 24Vdc adaptor.  These are £100 + shocking cost for something so simple!

Hi found a USA company that has a large selection of power accessories for CPAP and BIPAP machines, I e-mailed them with the specs on my machine and they confirmed the connection cables I asked for to connect to a car cigar lighter socket and also direct leads to a leisure battery for holidays etc. Contact www.CPAP.com

Update to previous



Sleep2snore said:

A thing to watch when using DC power leads is some machines use the centre pin being negative instead of positive as in most cars these days, so be careful when connecting DC power leads.

By putting a bridge rectifier between the input connector and the unit, the polarity of the voltage applied to the input connector becomes irrelevant.

The polarity at the output of the bridge will always be the same.  

The bridge could also be mounted as an external adaptor between the unit's connector and the voltage source.

I asked Resmed and got this link from them, still not cheap though.

https://mysleep.resmed.com/GB/en/Sleep-Apnoea/Accessories/AirSense-...

I suppose I could fit a 12v ciggy socket near where I sleep, and plug in one of those coke can type inverters, but as it will be running a motor, would it not need to be pure sine wave.

That is under debate, they said at a conference that it had to be a pure sine wave, now they have said in America that it does not have to be.  Sometimes you just so not know what to believe.

A pure sine wave might be better for you and the machine, but if it is just now and again, I would not worry to much about it.

What I would do is ask ResMed, if they say it is fine to use a non-sine wave one that is fine, but I would get this in an email to cover yourself against damage.  If you are not moving every day, I would buy a deep cycle battery, the power supply will cat off when the battery voltage drops below a certain level, but it might be to late to start your engine.   Charge it up in tandem with a non-return diode and a charging circuit to keep it topped up.

Reply to Discussion

RSS

Sleep Apnoea Forum

New to the Sleep Apnoea Forum? 

1. Stop by our Sleep Apnoea Welcome Center to introduce yourself to the SleepGuide community.
2. Start a New Topic of Conversation.
3. Post your photos - of yourself, your old CPAP machine, your new CPAP machine, your pet, something about you!

Interested in advertising, have a problem or need to contact us? Click the Report an Issue page.

 

Latest Activity

Edam replied to Edam's discussion Double inhaling
"I have been using   Remstar and S9 APAP,s for about 9 years now and my COPD was diagnosed at the same time. A consultant wanted to stop my Steroid inhaler completely as my COPD was not bad enough to require it but the nurse just…"
Tuesday
Sleep2snore replied to Chris Vesey's discussion Medistron batteries
"It is always good to have a dealer that you can trust and will sort out problems when they arise. It is always nice to have someone that has the time to sort things out with a customer and take time to do it rather than some salesman that don't…"
Tuesday
Sleep2snore replied to Edam's discussion Double inhaling
"Well the inhaler makes the lungs open up and if anything the dryness from a CPAP will dry them up and shut them down again. I am no doctor, but if you needed an inhaler before CPAP you would certainly need one after you start. Why did they cut you…"
Tuesday
Sleep2snore replied to Edam's discussion Twisted strap ouchhh!!
"What kind of strap is it, is it a cloth one or a silicone one? If it is a cloth one you could sew a strip along it to give it a bit more rigidity/stiffness. If it is a plastic one or a silicone one you could sew a bit of fabric round it to make it…"
Tuesday
Edam replied to Edam's discussion Twisted strap ouchhh!!
"I twisted the forehead strap again last night and OUCH!! Can anybody suggest a full face mask without the forehead strap. I cant use the Resmed Airfit masks as I seem to be exactly between sizes "
Tuesday
Edam replied to Edam's discussion Double inhaling
"Using the  increased steroid dosage inhaler, 200 /6 rather than 100/6, has reduced my 95% pressures by about 5 cm. Doing some detective work I have found that I was put onto a lower dosage inhaler in May last year. I think that is when the…"
Tuesday
John Wilkinson replied to John Wilkinson's discussion I've 'hit a wall' can any body help me?
"Thanks for your advice. I really appreciate your help. I wasn't aware that there different types of apnoeas. I will be seeing the sleep nurse next week. I will keep you informed. John "
May 17
John Wilkinson replied to John Wilkinson's discussion I've 'hit a wall' can any body help me?
"Thanks for that Kath. I am due to see the sleep clinic next week. Hopefully they will re-adjust the pressure. I will keep you informed. John"
May 17
Edam replied to Edam's discussion Double inhaling
"I have read that APAP machines are not suitable for people with Asthma and give the same problems that I have been having. I am now having to use twice the dose of steriods just to keep the APAP happy If I can ever get in touch with my hospital I…"
May 17
Kath Hope replied to Chris Vesey's discussion Medistron batteries
"Thanks Chris and we certainly are doing our homework Sleep2Snore.  Our charity work hard to get the right products at the right price for our fellow sufferers, and we have lots of loyal customers who purchase from us both to support the charity…"
May 17
Kath Hope replied to John Wilkinson's discussion I've 'hit a wall' can any body help me?
"Sorry to hear after a good start you've taken a step backwards, and it could well be due to the reduction in pressure.  We don't recommend adjusting pressures but you're right to contact your hospital who will probably re-adjust…"
May 17
Sleep2snore replied to John Wilkinson's discussion I've 'hit a wall' can any body help me?
"They have reduced it to far.  The max was 16, they should have left the machine at 18 if it is an APAP (automatic pressure) if it is a CPAP you have now same applies.  However, it might not be quite that straight forward as that as the…"
May 16
John Wilkinson posted a discussion

I've 'hit a wall' can any body help me?

I was diagnosed with severe OSA in November and I have been using a Philips Respironics CPAP machine and full face mask from early December up to now (about 5 months). My HPI's went down from 44 to about  14 in about 10 weeks and I was feeling much…See More
May 16
Sleep2snore replied to Chris Vesey's discussion Medistron batteries
"They are very costly things to have sitting around to go wrong or if you forget to charge them by their date. You could try to see if they will do it on a sale or return basis, them you could keep one or two.  However, I think most are ordering…"
May 15
Chris Vesey replied to Chris Vesey's discussion Medistron batteries
"Hi, I see from medistrom website they are looking for dealers, is it worth considering Kath"
May 15
Sleep2snore replied to Chris Vesey's discussion Medistron batteries
"I wish the ResMed was 12Vdc, it would make life a lot easier. I wonder why they need 24Vdc anyway? My APAP is not mine to and see why it has to be 24Vdc! I don't think the clinic might be to impressed if I opened it for a look. "
May 14
Sleep2snore replied to Edam's discussion Double inhaling
"I would like to see how the hospital is going to explain that your Apnoea is getting worse with an AHU of 0. That is almost incompetent. It might also be that it is not straight forward Sleep Apnoea you have and might benefit from an advanced…"
May 14
Chris Vesey replied to Chris Vesey's discussion Medistron batteries
"hi, just looked on internet, it seems that medistrom may not have a dealer in the uk but a company called sleep tight advertise the pilot 24 for £345, don't know about the co pilot. The very expensive one on amazon comes from Israel, good…"
May 13
Chris Vesey replied to Chris Vesey's discussion Medistron batteries
"hi, at the time amazon were selling the pilot for £285 and the co pilot for £137, gone up a lot since then chris"
May 13
Edam replied to Edam's discussion Double inhaling
"I have read that if you have Asthma a CPAP is better than a APAP  When the APAP increases the pressure it makes the asthma worse and then the APAP increases the pressure again which makes the asthma even worse ..... This is exactly whats…"
May 13

© 2018   Created by The SleepGuide Crew.   Powered by

Badges  |  Report an Issue  |  Terms of Service