"Just to tidy this up, I finally had an in-person review by my sleep clinic yesterday, who agreed the ResMed AirSense 10 was "wheezy" and replaced the machine."
Sleep Apnoea Forum Bringing Help + Support to the Patient
DeVilbiss D100F full face mask review
DeVilbiss D100 Full Face Mask review
I have spent a week using the new DeVilbiss D100 full face mask. I am mostly a nasal mask user however I keep a full mask on hand for those times where congestion or irritation requires it.
The mask is a basic, simple clear hard plastic mask with a silicone seal that is easy to detach and reattach for cleaning. It has a short highly flexible hose attached and a swivel elbow. Venting is through four relatively large holes in the elbow, and the entrainment valve (to enable breathing if the air supply fails) is below this and blocks the air inlet, breathing is then through the elbow (that sounds odd when I read it back). There is a forehead stabiliser which is adjusted by changing the silicone pad for a choice of three sizes. Headgear is basic but has quick release clips and a fixed crown strap.
Fitting was easy, it seems to need a tighter fit than say a Resmed Quattro FX, but not as tight as the Fisher and Paykel Forma. Once in place and with the air flow on it seemed remarkably well sealed and easy to breathe out through. First night was fine, it is well designed as far as my face is concerned. Seal stayed in place all night. The short extra flexible hose certainly helps. Venting is very quiet, however it is a very direct jet.
However, this is not a mask for side or front sleepers. It is quite wide and deep and dislodges easily in contact with a pillow or mattress. Noisy and irritating leakage is then the result (whistles and farts!). Sleeping on your back though means the vent is not directed at your partner.
Cleaning is simple, pull off the silicone, hand wash it, wipe the mask around with a mask wipe or wash it and dry it. Easy and quick. No marks from the headgear or the mask on my face either which is good.
I found myself feeling quite dry upon waking so I increased the humidity on my machine (Fisher and Paykel Icon Auto). This is where a problem became evident, the hard shell of the mask is very thermally conductive, so the warm humid air from the machine meets the cold shell and condensation (rain out) occurs, this is in addition to the condensate from exhalation. This is a mask that you can watch fogging as you breathe into it looking in a mirror. The condensation runs down to the seal and the mask then slips and leaks. I turned it down night by night, my machine has a scale of 1 to 7 and anything above 4 causes rain-out.
In conclusion this is a good fitting mask that is lightweight and easy to use but limiting for side sleepers, and flawed in many ways. If you want an easy, well fitting lightweight mask that is very clear (good for watching TV in bed) then this may be worth a try. If you like the humidity up high then this is not for you.
I have stuck this in my travel bag, it is smaller and lighter than the Forma and seals better than the Quattro FX.
I have spent a week using the new DeVilbiss D100 full face mask. I am mostly a nasal mask user however I keep a full mask on hand for those times where congestion or irritation requires it.
The mask is a basic, simple clear hard plastic mask with a silicone seal that is easy to detach and reattach for cleaning. It has a short highly flexible hose attached and a swivel elbow. Venting is through four relatively large holes in the elbow, and the entrainment valve (to enable breathing if the air supply fails) is below this and blocks the air inlet, breathing is then through the elbow (that sounds odd when I read it back). There is a forehead stabiliser which is adjusted by changing the silicone pad for a choice of three sizes. Headgear is basic but has quick release clips and a fixed crown strap.
Fitting was easy, it seems to need a tighter fit than say a Resmed Quattro FX, but not as tight as the Fisher and Paykel Forma. Once in place and with the air flow on it seemed remarkably well sealed and easy to breathe out through. First night was fine, it is well designed as far as my face is concerned. Seal stayed in place all night. The short extra flexible hose certainly helps. Venting is very quiet, however it is a very direct jet.
However, this is not a mask for side or front sleepers. It is quite wide and deep and dislodges easily in contact with a pillow or mattress. Noisy and irritating leakage is then the result (whistles and farts!). Sleeping on your back though means the vent is not directed at your partner.
Cleaning is simple, pull off the silicone, hand wash it, wipe the mask around with a mask wipe or wash it and dry it. Easy and quick. No marks from the headgear or the mask on my face either which is good.
I found myself feeling quite dry upon waking so I increased the humidity on my machine (Fisher and Paykel Icon Auto). This is where a problem became evident, the hard shell of the mask is very thermally conductive, so the warm humid air from the machine meets the cold shell and condensation (rain out) occurs, this is in addition to the condensate from exhalation. This is a mask that you can watch fogging as you breathe into it looking in a mirror. The condensation runs down to the seal and the mask then slips and leaks. I turned it down night by night, my machine has a scale of 1 to 7 and anything above 4 causes rain-out.
In conclusion this is a good fitting mask that is lightweight and easy to use but limiting for side sleepers, and flawed in many ways. If you want an easy, well fitting lightweight mask that is very clear (good for watching TV in bed) then this may be worth a try. If you like the humidity up high then this is not for you.
I have stuck this in my travel bag, it is smaller and lighter than the Forma and seals better than the Quattro FX.
Views: 50
Replies to This Discussion
-
Permalink Reply by Kath Hope on
-
How would you compare it to the F & P 431/432 Symmit, as I quite like the 431 - especially the chin support?
About
Sleep Apnoea Forum
New to the Sleep Apnoea Forum?
1. Stop by our Sleep Apnoea Welcome Center to introduce yourself to the SleepGuide community.
2. Start a New Topic of Conversation.
3. Post your photos - of yourself, your old CPAP machine, your new CPAP machine, your pet, something about you!
Interested in advertising, have a problem or need to contact us? Click the Report an Issue page.
Latest Activity
"thank you jonathan,i did get the it pack so tried the small and still struggled but i was sat up in bed so will try lying down great suggestion "
"Hi
My first thought is "don't panic"! We're all a bit different, and there are many things that can be tweaked. I took to CPAP therapy like a duck to water, but I've had friends who say they can't cope, but…"
1st time and I’ve failed the mask leak test
Hi everyone, today I received my rental kit - prisma smart max, plus a Philips dreamwear mask which I’ve been wearing unconnected to try and get used to it. I just did a mask fit test using a medium mask and got a constant red/orange leak warning…See More
Are every small CPAP machines any good?
Travel sized, micro - any good?See More
"Ha well it lasted a couple of days but started howling again. But it's a step in the right direction, just needs a bit more work."
"Nope, I just accept that some people's throats tend to close when they sleep, due to a loss of muscle tone during deeper sleep. Back when I was diagnosed, the sleep lab just filmed you whilst you slept, stuck an O2 meter on your finger,…"
"Did anyone tell you exactly what the anatomical issue is, Jonathan?"
"Can't say I know about this."
"So I tore some fabric from one of the filters and glued it over the holes - and it worked!It was dead quiet, and the air was still flowing freely.It was quiet all night then after a few hours a bit of whistling until I gave it a wipe.Vast…"
"Hi Jonathan, well see my nose is blocked a lot, so I mouth breath which really sucks a lot more moisture and makes my mouth dry. So I put humidity on maximum, which makes for condensation at the mask end, which becomes a demonic reed instrument.Now…"
ResMed AirSense 10 getting noisy
HelloI have an NHS issued ResMed AirSense 10 with heated humidifier. In the last couple of weeks, it's developed an annoying noise, when I inhale. It bothers me a little and my partner a lot! I sometimes get problems if the water container in the…See More
"Hi
My first question is why is condensation forming? I very occasionally get some condensation, may be once a month, but I can quickly run a finger around the inside of the mask, and wipe it away. I use a nasal mask, with the humidifier…"
"11K+? Ok that's probably where I should look then :-)"
"Hi John. Thanks for the compliment as I do my best popping on here, but it's difficult due to us now supporting 25k+ patients at the charity. To be honest, the forum is quiet because most people seem to prefer Facebook and forums aren't as…"
"There's some information here, but generally it's very common and likely due to our anatomy."
© 2024 Created by The SleepGuide Crew.
Powered by
