Hope2SleepGuide

Sleep Apnoea Forum Bringing Help + Support to the Patient

How is it decided what machine I need?

At present I use a S9 Apap  with the EPR set at 3 but I feel that a Bipap would be better for me.

Views: 303

Reply to This

Replies to This Discussion

An APAP with EPR is almost Bipap.

The Sleep Centre would know from their readings if you would be better with another type of machine, if you had a home study you need to take it up with your GP and raise it with your Sleep Centre.

I checked with my hospital but they dont supply Bipap,s to outpatients so looks like Im stuck with the S9

You can always ask to be transferred to another hospital if there is one near you.

Or you can buy one of you can afford one and ask if they will service it and repair it if you buy one, some hospitals will and others will not.  But in any case, if it breaks down you will have to wait, but they may give you a loan APAP until it is repaired.

Worth a try, you have nothing to loose.

But before you go down that route, ask if they think you need one.

Its not easy to get transferred to another local  hospital as I am finding out.

Rather than getting a appointment for my local hospital ,which supplies Philips machines, I have been given a appointment for a London Sleep Clinic instead.

I will have to cancel that one.

I have increased the minimum pressure to 14 as I have seen, on Sleepyhead, that the pressure tends to shoot up to 20 when the pressure has dropped to 12.. Increasing the minimum pressure to 14 does reduce the amount the pressure is bouncing around

Look for your 90% and set the low pressure just below that or on that figure and it should behave a lot better.

It is 90% that most clinics set a CPAP at, this covers most events without undue pressure and a bit of discomfort.

My ResMed machine was set by the clinic to 8 and 20 when I got it, but since then I have moved the low pressure to 11 and left it at 20, it has never gone above 13,5.  Before I did this the pressure used to rise suddenly and wake me up, so I took the lower pressure nearer the higher pressure, Now I have no problems, but I do get an angry red face every now and again, due to air escaping out of my mouth through my lips.  Very little I can do about that, but the highest I have ever got was a 1 and it is normally 0.0 to 0,4 at worst.

 Last month my 95% pressure varied from a minimum of 14.9 to a maximum of 19.8 this makes it rather difficult to set a range    I was thinking about setting it up to be a CPAP, which the S9 Autoset can do, but with the 95% pressure varying so much   what pressure would you set it to.

As you say that would be difficult.  I would keep it in APAP mode.  All you can do is to keep the high pressure open and start with the low at 10 and go up a step at a time and see where you do best, though if your needs change so much you may need a more advance machine.  If your hospital does not supply them then your only option is to go to another hospital that does or talk to the consultant to see if he thinks you need one.  Then go buy one if they will look after it and service it.  The only thing that they would not have for it would be the machine itself if it did break down.  You would need to get the same brand that they deal with of they agreed to look after it.

It is worth a try, you have nothing to loose and everything to gain.

Sleepyhead YouTube.  Sleepyhead on YouTube

It is my understanding that when a new sleep test is required you need to be off CPAP for a few days to get a accurate test. Is this correct

The London hospital does not seem to be aware of this

I was not off for a few days.

The results were the same as when I started!

Which I have to say was bad!

On saying that, it takes a few days before you yourself feel the affects, usually.

But as far as the results of a sleep test, I don't think it would make ant difference as your throat will still close etc.

I am now finding that the pressure the APAP runs at during the night is dependent  on what I have eaten that evening.

I have found that if I have bolied rice rather than chips with the evening meal then my 95% pressure can reduce by as much as 3 cm.

Im beginning to think that Im having a allergic reaction to something which is affecting my breathing

That is not impossible, even dust and mites can cause problems, even the mites that are so tiny you can't see them and they live on your body.  However, only you yourself can work out if certain food make things worse.  It could be that you like chips more and eat more of them lol.  3cm is quite a bit, I am fairly constant in my max pressure, however, I am not the same every night with AHI.  Some nights and usually not more then 0.3AHI but I have been as high as 1AHI, but that was a night where I was suffering badly with the cold and was a bit choked up.  The worst I usually get on a bad night otherwise is 0.4AHI with no Central or other complicated Apnoea.  I used to have a few central ones until I got the APAP, then they for the most part have been history.  I think the central ones were caused as I used to run the CPAP over pressure to allow for constant leaks.

Mabe just note your AHI every morning against what you ate the night before and see if it does affect it.

I have to say though, the only thing I have seen reported is drink affecting the AHI, and it can be quite a bit!

Reply to Discussion

RSS

Sleep Apnoea Forum

New to the Sleep Apnoea Forum? 

1. Stop by our Sleep Apnoea Welcome Center to introduce yourself to the SleepGuide community.
2. Start a New Topic of Conversation.
3. Post your photos - of yourself, your old CPAP machine, your new CPAP machine, your pet, something about you!

Interested in advertising, have a problem or need to contact us? Click the Report an Issue page.

 

Latest Activity

Jonathan replied to Jonathan's discussion ResMed AirSense 10 getting noisy
"Just to tidy this up, I finally had an in-person review by my sleep clinic yesterday, who agreed the ResMed AirSense 10 was "wheezy" and replaced the machine."
Nov 9
Collette rose replied to Collette rose's discussion 1st time and I’ve failed the mask leak test
"thank you jonathan,i did get the it pack so tried the small and still struggled but i was sat up in bed so will try lying down great suggestion "
Nov 3
Jonathan replied to Collette rose's discussion 1st time and I’ve failed the mask leak test
"Hi My first thought is "don't panic"!  We're all a bit different, and there are many things that can be tweaked.  I took to CPAP therapy like a duck to water, but I've had friends who say they can't cope, but…"
Nov 2
Collette rose posted a discussion

1st time and I’ve failed the mask leak test

Hi everyone, today I received my rental kit - prisma smart max, plus a Philips dreamwear mask which I’ve been wearing unconnected to try and get used to it. I just did a mask fit test using a medium mask and got a constant red/orange leak warning…See More
Nov 2
Collette rose is now a member of Hope2SleepGuide
Oct 31
John posted a discussion
Oct 30
Profile IconBill Wright, Nicole Watson, TJ Bennett and 2 more joined Hope2SleepGuide
Oct 29
John replied to John's discussion evil mask noise
"Ha well it lasted a couple of days but started howling again. But it's a step in the right direction, just needs a bit more work."
Oct 24
Jonathan replied to John's discussion Has anyone been told root cause of their OSA?
"Nope, I just accept that some people's throats tend to close when they sleep, due to a loss of muscle tone during deeper sleep.  Back when I was diagnosed, the sleep lab just filmed you whilst you slept, stuck an O2 meter on your finger,…"
Oct 24
Jonathan replied to John's discussion evil mask noise
"Good to know you found a solution!"
Oct 24
John replied to John's discussion Has anyone been told root cause of their OSA?
"Did anyone tell you exactly what the anatomical issue is, Jonathan?"
Oct 21
John replied to Jonathan's discussion ResMed AirSense 10 getting noisy
"Can't say I know about this."
Oct 20
John replied to John's discussion evil mask noise
"So I tore some fabric from one of the filters and glued it over the holes - and it worked!It was dead quiet, and the air was still flowing freely.It was quiet all night then after a few hours a bit of whistling until I gave it a wipe.Vast…"
Oct 19
John replied to John's discussion evil mask noise
"Hi Jonathan, well see my nose is blocked a lot, so I mouth breath which really sucks a lot more moisture and makes my mouth dry. So I put humidity on maximum, which makes for condensation at the mask end, which becomes a demonic reed instrument.Now…"
Oct 17
Jonathan posted a discussion

ResMed AirSense 10 getting noisy

HelloI have an NHS issued ResMed AirSense 10 with heated humidifier.  In the last couple of weeks, it's developed an annoying noise, when I inhale. It bothers me a little and my partner a lot! I sometimes get problems if the water container in the…See More
Oct 16
Jonathan replied to John's discussion evil mask noise
"Hi My first question is why is condensation forming?  I very occasionally get some condensation, may be once a month, but I can quickly run a finger around the inside of the mask, and wipe it away.  I use a nasal mask, with the humidifier…"
Oct 16
John replied to John's discussion What's a good Apnea forum?
"11K+? Ok that's probably where I should look then :-)"
Oct 16
Kath Hope replied to John's discussion What's a good Apnea forum?
"Hi John. Thanks for the compliment as I do my best popping on here, but it's difficult due to us now supporting 25k+ patients at the charity. To be honest, the forum is quiet because most people seem to prefer Facebook and forums aren't as…"
Oct 16
John posted discussions
Oct 16
Jonathan replied to John's discussion Has anyone been told root cause of their OSA?
"There's some information here, but generally it's very common and likely due to our anatomy."
Oct 12

© 2024   Created by The SleepGuide Crew.   Powered by

Badges  |  Report an Issue  |  Terms of Service